Corrkil

Method of Application

Remove the thick scales of rust on the metal surface with mild hammer strokes and clean ut the surface thoroughly by scratching with metal shrapnel and steel-wire brushes. Then remove the loose rust particles on the metal surface by rubbing with dry cloth. Remove the stains of grease or oils, if any, on the metal surface by cleaning with kerosene or petrol. Make sure that the cleaned metal surface is completely dry before application. On the clean and dry metal surface, first give a coating of CORRKIL-PA. After 24 hours apply One sval of CORRKIL-EP(Primer) and allow to dry for one day. Then give two even coat of CORRKIL-E the Top Coat, each coating at an interval of one day. Please note, our Products being Solvent-based, the first coating does not give a complete hiding of the lower surface. The final coating, however, produces a total hiding of the lower surface. While giving the coatings, do not unduly rub the brush for a long time over the same spot. This leads to the formation of plastic fibres on the brush which disturb the coating with the pulling effect. In fact, this is a peculiar property of CORRKIL-E. To avoid fibres, again take a little freah material or thinner on the brush and make an even coating. The surface of the coating becomes tack-free within six hours and dries up completely within 24 hours. Total hard drying through complete cross-linkages of the Co-polymer takes about a week. Please also shake/mix well before applying.